Applying your decal and Care Tips
We highly recommend the wet method to apply our decals.
The spray solution is a dab of dawn soap and rest warm water.
Sticker and Decal Care and Application
Vinyl Decal Care Instructions
To maintain the integrity and appearance of your Down2Shine decal and to remain eligible for warranty coverage, please follow these care guidelines:
Cleaning & Maintenance
• Wait 48 hours after application before washing the surface.
• Clean regularly using mild soap and water—avoid harsh chemicals, bleach, or ammonia-based cleaners.
• Use a soft microfiber cloth or sponge. Do not scrub with abrasive materials or brushes.
• Avoid automatic car washes with brushes; hand washing is strongly recommended.
• Do not pressure wash directly over the decal or edges.
Environmental Protection
• Whenever possible, park in shaded or covered areas to reduce prolonged UV exposure.
• Avoid applying wax, sealants, or ceramic coatings directly over the decal unless they are vinyl-safe.
Damage Prevention
• Do not pick at or peel the edges of the decal.
• If you notice lifting, bubbling, or edge wear, contact Down2Shine Detailing LLC immediately for assessment.
• Do not attempt to reapply or reposition the decal once installed.
How to Apply Your Down2Shine Vinyl Decal
For best results, follow these steps carefully. Improper application may void your 1-Year Weather Warranty.
What You’ll Need:
• Clean microfiber cloth
• Rubbing alcohol or mild soap and water
• Squeegee or credit card
• Masking tape (optional for larger decals)
Step 1: Prepare the Surface
Clean the application area thoroughly using rubbing alcohol or mild soap and water. Remove all dirt, wax, and residue. Dry completely with a lint-free cloth.
Tip: Avoid applying in extreme heat or cold. Ideal temperature is between 60–80°F.
Step 2: Position the Decal
Without removing the backing, place the decal where you want it. Use masking tape to hold it in place if needed. Step back and check alignment.
Step 3: Peel the Backing
Slowly peel the white backing paper away from the decal, ensuring the vinyl stays attached to the clear transfer tape.
Step 4: Apply the Decal
Carefully place the decal (with transfer tape) onto the surface. Start from one edge and press down gradually to avoid air bubbles. Use a squeegee or credit card to firmly smooth the decal from the center outward.
Step 5: Remove the Transfer Tape
Wait 1–2 minutes, then slowly peel away the clear transfer tape at a sharp angle. If any part of the decal lifts, press it back down and wait a bit longer before retrying.
Final Touch:
Let the decal cure for 48 hours before washing or exposing it to rain. Avoid pressure washing or waxing over the decal.